The Snapset I Packer is a compression set
packer requiring only straight set down
weight to pack-off. This packer is run
above other packers (such as the ASI-X
Packer, AS-II Packer or AS-III Packer)
for selective production to isolate casing
holes and perforations.
This packer has no upper or lower slips and
should be used only where intermediate
differential pressures from below are
expected. This packer has an internal latch to prevent the packer from setting
prematurely when running down the hole.
When releasing, the latch re-engages to
allow movement downhole and re-setting.
Special Features
> Large internal by-pass
> Set down to pack off, pick up to release
> Compact design
packer requiring only straight set down
weight to pack-off. This packer is run
above other packers (such as the ASI-X
Packer, AS-II Packer or AS-III Packer)
for selective production to isolate casing
holes and perforations.
This packer has no upper or lower slips and
should be used only where intermediate
differential pressures from below are
expected. This packer has an internal latch to prevent the packer from setting
prematurely when running down the hole.
When releasing, the latch re-engages to
allow movement downhole and re-setting.
Special Features
> Large internal by-pass
> Set down to pack off, pick up to release
> Compact design
